The water stabilized mixing plant has a service life. If we want to make Jinan water stabilized mixing plant run smoothly forever, we need good maintenance and careful use to extend its service life. The following editor will explain to you:
When the water stabilized material mixing plant is shut down, it is strictly forbidden to carry materials in the whole production line. In special circumstances (such as machine failure), when it is not stopped manually, it is necessary to clean the materials in the line before starting. The machine is strictly prohibited to start with full load and overload.
The silo vibrator shall not vibrate in the air or for a long time (when there is no material or little material in the silo). The operator shall do his duty, stop the machine immediately in case of any problem, and the machine shall not work with disease, and the operator shall not leave the post without permission. In order to ensure the continuous blanking of aggregate silo and the measurement accuracy, other materials except sand and stone (soil, lime, pulverized coal, etc.) must be fed by belt loader, and direct loading by loader, truck or excavator is not allowed. Strictly ensure the particle size and water content of various raw materials.
The water-stabilized mixing plant must be installed stably and firmly in safety, and a rain-proof, anti-smashing or thermal insulation work shed must be set up. The operation site should always be kept clean and tidy. A sedimentation tank should be dug outside the shed to drain the waste water from cleaning machinery. The power supply wiring must be correct, and there must be reliable protective neutral connection (or protective grounding) and leakage protection switch. The wiring and insulation of each part must meet the specified requirements.
(Operated by electricians) The operators must be trained, pass the examination and obtain the operation certificate. Non-operators are prohibited to operate. The operator must carefully maintain the water stabilized mixing plant every time according to the cross operation method of cleaning, fastening, lubricating, adjusting and anti-corrosion.
At the beginning of each work, carefully inspect all parts for abnormalities. Before starting the machine, check whether all parts are damaged, whether they are in good condition, whether the machine body is balanced, and whether there are obstacles around. Only when it is confirmed that there are no problems can the machine be switched on and tested.
After the test run for 2~3 minutes, the drum rotates evenly, without jumping, deviation, normal operation, and no abnormal noise, the formal production operation can be started. After the machine is started, the driver must concentrate on his/her position and not leave without permission.
Pay attention to the operation of the machinery at any time. If abnormal phenomena are found or abnormal noises are heard, the stored materials in the mixer must be discharged and the machine must be shut down for maintenance. When the water stabilized mixing plant is in operation, it is strictly forbidden to repair and maintain it, and it is not allowed to use tools to stretch into the drum to pick up materials. Come to our website for more relevant content http://www.ycgjglcl.com Ask!